After using the automatic concrete feeding mixer for a period of time, we often encounter the blockage of the feeding port. Today, we will teach you how to deal with the blockage of the feeding port?
1. Thoroughly clean the concrete storage tank and the area around the inlet and outlet at the end of each day. The key points for cleaning the automatic feeding mixer truck shall ensure that there is no cement and concrete caking; Note that the feed inlet shall be flushed with water before each loading, so as to keep the feed inlet wet during loading.
2. While loading, fill the water tank with water for cleaning that is provided with the vehicle; Flush the feed inlet after loading, and clean the residual concrete near the feed inlet; After unloading at the construction site, flush the discharge chute, and then add 30-40 L of cleaning water to the concrete storage tank; Keep the concrete tank rotating slowly in the forward direction during the vehicle return; Remember to drain the sewage in the concrete storage tank before the next loading.
3. Whether the feeding amount at the feeding port of the automatic feeding mixer is reasonable: the correct way is to form a certain mixture ratio of air and material at the suction port, and the material will flow into the feeder evenly under the promotion of the air flow. At this time, we need to design the charging gun with the air supplement function. If the material is overstocked for a long time, it may be very hard. At this time, an oscillator needs to be installed on the material gun to break the caked material.
The above is a detailed introduction to the fully automatic self loading mixer, and I hope it will be helpful to you. If you have any questions, please contact us. We will provide you with our attitude http://m.privatsexgirls.com/